Pickleball court dimensions and contractor striping guide

Use the official 20 ft by 44 ft court layout, then switch to center marks when you are taping or striping from the middle of a 2 in line.

Step-by-step layout mode

The large grid diagram below highlights one contractor step at a time with the active measurement labels.

Contractor striping steps

1

Step 1 of 16

Prepare the court

Clean the striping area and confirm repairs and color coating have cured before any centerline layout marks are placed.

Use compatible athletic-court line paint for professional acrylic courts, not ordinary traffic or latex paint.

Official playing lines20 ft x 44 ft

Measured to outside edge of perimeter and non-volley-zone lines.

Contractor line centers43 ft 10 in by 19 ft 10 in

2 in lines put each line center 1 in inside the official outside edge.

Minimum playing surface30 ft x 60 ft

Practical minimum surface around the court.

Preferred new construction34 ft x 64 ft

Preferred new-construction and tournament planning surface.

Layout points

Use these point names with the step-by-step contractor line-center method.

A
center of the court at the net
B1
sideline center at the net
B2
opposite sideline center at the net
C1
first baseline corner
C2
other corner of the first baseline
C3
opposite baseline corner
C4
opposite baseline corner
D1
first kitchen-line corner
D2
first kitchen-line corner
D3
opposite kitchen-line corner
D4
opposite kitchen-line corner
E1
first service-center-line baseline endpoint
E2
first service-center-line kitchen endpoint
E3
opposite service-center-line baseline endpoint
E4
opposite service-center-line kitchen endpoint

Line-center layout measurements

Use these values when the chalk mark or tape-machine path is the center of a 2 in painted line.

Court width19 ft 10 in
Half court width9 ft 11 in
Net to baseline center21 ft 11 in
Court length43 ft 10 in
Net to kitchen-line center6 ft 11 in
Baseline center to kitchen-line center15 ft
Half-court corner diagonal29 ft 6.75 inField-friendly rounded value from the line-center points.
Full-court centerline diagonalabout 48 ft 1.375 inThe two full diagonals should match each other.

Square-check measurements

Verify the centerline layout before snapping tape or painting.

B1 to B219 ft 10 in
C1 to C219 ft 10 in
C3 to C419 ft 10 in
C1 to C3 along one sideline43 ft 10 in
C2 to C4 along opposite sideline43 ft 10 in
Net to either baseline center21 ft 11 in
C1 to C4 and C2 to C3about 48 ft 1.375 inMore important than the rounded value: both diagonals should match.

Finished official checks

These are outside-edge finished court checks after 2 in lines are painted.

Outside sideline to outside sideline20 ft
Outside baseline to outside baseline44 ft
Net to outside edge of baseline22 ft
Net to outside edge of kitchen line7 ft
Outside sideline to court center10 ft
Line width2 in
Outside corner-to-corner diagonalabout 48 ft 4 in
Layout note

All pickleball court lines are 2 in wide and should contrast with the surface.

Layout note

The non-volley-zone line is 7 ft from the net in official layout; for a centerline tape mark, use 6 ft 11 in from the net.

Layout note

Do not mix line-center layout marks with official outside-edge measurements on the same field layout.

Layout note

The site estimator uses 30 ft x 60 ft as the practical planning pad unless the court is shaped larger.

USA Pickleball official rulebook

Source checked 2026-08-27.

Review source
USA Pickleball court construction guidance

Source checked 2026-08-27.

Review source

Use the measurements before the quote request.

These dimensions help you plan the layout. The calculator prices the scope, the colorizer previews the surface, and the map estimator places the court, fencing, lighting, and related items on the property.