St. George Patio Cost: 2026 Prices by Size and Material

Most St. George homeowners pay roughly $6 to $18 per square foot for a concrete patio, depending on finish, and $15 or more per square foot once you move to pavers or natural stone. Locally published rates put a 400-square-foot patio anywhere from about $2,400 for plain broom-finish concrete to $10,000 or more for stamped or stone work. The spread comes from your yard, not just the material: slope, access, base prep and drainage move the number more than most people expect. The reliable way to land on your own figure is to measure the exact footprint on aerial imagery and send that scope to contractors. Our Concrete Estimator lets you draw the patio on your own lot, get a locally adjusted range, and request quotes without creating an account.
TL;DR
- Plain broom-finish concrete in St. George is published at about $6 to $9 per square foot installed, and stamped or decorative concrete at $10 to $18 per square foot.
- Pavers run about $15 to $25 per square foot locally and natural stone $15 to $40, so a 500-square-foot patio can double in price based on material alone.
- Small patios cost more per square foot: many contractors set a minimum charge, so a 12-by-12 pad is priced by the job, not by the foot.
- Base prep, drainage, access and demolition are the usual reasons a final quote lands above the headline rate.
- A measured drawing of your patio, with dimensions, finish and extras, gets you quotes you can compare line by line.
Table of Contents
- What a patio costs in St. George, by material
- Worked examples: 12x12, 300 sq ft and 400 sq ft
- Concrete, pavers or stone in St. George
- What moves your St. George patio quote
- How to price your own patio step by step
- Reading and comparing patio bids
- Our perspective
- Draw your patio and get a St. George range
- FAQ
- Sources
What a patio costs in St. George, by material
Local contractors publish their own rates, and they do not agree exactly. That is normal: each prices different finishes, crew sizes and base standards. The table gathers the ranges published for St. George and Southern Utah, all-in for labor, materials and site prep unless noted.
| Patio type | Published range per sq ft | Typical 400 sq ft patio |
|---|---|---|
| Plain broom-finish concrete | $6 to $9 (St. George contractor, current rate page); $8 to $15 (another local contractor) | $2,400 to $7,200 |
| Stamped or colored concrete | $10 to $18 (local rate page); $12 to $25 (local contractor guide) | $4,000 to $10,000 |
| Concrete pavers | $15 to $25 (local guide, January 2026) | $6,000 to $10,000 |
| Natural stone | $15 to $40 (Southern Utah guide, June 2026) | $6,000 to $16,000 |
A separate St. George rate table updated in 2026 starts basic broom-finish patios at $6 per square foot and stamped or decorative work at $12 per square foot. It also says site access, slab thickness and base preparation affect the final cost, which is the theme of the rest of this guide.
The wide bands are not sloppiness. Two quotes for the same patio can differ by 30 percent or more because one includes a thicker slab, a compacted gravel base and sealer, and the other does not.

Worked examples: 12x12, 300 sq ft and 400 sq ft
Square-foot rates only help when you can turn them into a total. Here are the three sizes homeowners search for most.
A 12-by-12-foot concrete patio
That is 144 square feet. At the $6 to $9 local plain-concrete rate, simple multiplication gives about $864 to $1,296. In practice you should expect more. Concrete Network’s 2026 patio guide lists $900 to $3,000 for a 12-by-12 patio and notes that small jobs may fall under a contractor minimum rather than a straight per-foot rate. A national 2026 breakdown puts those minimums at $1,500 to $2,500 for most contractors.
Plan on roughly $1,500 to $3,000 for a small plain patio, and expect a stamped finish on the same footprint to land toward the top of that range or above it. Small patios cost more per foot because crew setup, forming and truck delivery are fixed costs that do not shrink with the slab.
A 300-square-foot stamped concrete patio
At the national stamped range of $12 to $18 per square foot, a 300-square-foot patio costs $3,600 to $5,400. The same 2026 breakdown itemizes it this way:
- Concrete and base: $610 to $820
- Color hardener and release agent: $150 to $300
- Stamping labor: $1,800 to $3,000
- Two coats of acrylic sealer: $150 to $250
Notice that labor is more than half the bill. Stamping is skilled, time-sensitive work, which is why the finish matters more to price than the volume of concrete. Border stamps add roughly $3 to $5 per linear foot in that same breakdown. Our guide to stamped concrete quotes explains which scope lines to ask about: pattern, color, release, control joints, sealer and prep.
A 400-square-foot patio
This is a common size for a backyard dining area. Local contractor figures give $3,200 to $4,800 for basic concrete and $6,000 to $10,000 stamped in one St. George guide, while a Southern Utah hardscape guide from June 2026 puts a 400-square-foot patio at $6,500 to $10,000 across materials. Larger patios cost less per foot: the same spec that runs $12 to $15 per square foot at 100 square feet can drop to $6 to $9 at 400, according to a 2026 cost guide, because setup labor is spread across more area.
Concrete, pavers or stone in St. George
Concrete is the lowest-cost surface, and it holds up well in the desert when it is poured on a proper base. A January 2026 local comparison lists installed costs of $9 to $14 per square foot for concrete against $15 to $25 for pavers. On 500 square feet that is $4,500 to $7,000 versus $7,500 to $12,500. The same source puts annual upkeep at $50 to $150 for concrete and $200 to $400 for pavers.

Finish upgrades on concrete are priced as add-ons per square foot in that comparison: stamping adds $3 to $8, color $1 to $4, exposed aggregate $2 to $5 and scored patterns $1 to $3. That gives you a way to price your own wish list. A colored, scored patio is far cheaper than a stamped one, and many homeowners find it gives the clean look they wanted.
Natural stone sits at the top. At the $15 to $40 per square foot Southern Utah range, a 1,000-square-foot stone patio would run $15,000 to $40,000 installed. Stone and pavers also carry pattern work and a thicker compacted base, which is where much of that labor goes. If you are weighing the two main options, see our concrete versus paver patio cost comparison and our paver patio cost guide.
Heat matters here too. Southern Utah summers regularly top 100°F, and the Southern Utah guide above notes that material choice differs from northern Utah for that reason. Lighter colors and textured finishes stay more comfortable underfoot, so discuss surface color before you lock in a pattern.
What moves your St. George patio quote
The headline rate is only a starting point. These are the factors that push an actual quote up or down.
Size and shape. Bigger is cheaper per foot, curves and cutouts cost more than rectangles, and every added step or border adds labor.
Finish and pattern. Local rate pages show decorative pattern and color choices as the main finish levers. A broom finish is the baseline, and stamped patterns, borders and multiple colors each add to it.
Site prep and slope. Excavation, grading and compacting the subbase are part of a proper installation, and one local contractor lists them as price factors. A yard that needs more grading costs more, and so does one where equipment cannot reach.
Access. Concrete Network points to equipment access, demolition and grading as items that raise totals. A narrow side gate that forces wheelbarrow work changes the labor line.
Drainage. Drainage work such as a French drain or regrading can add $500 to $2,500 on a typical 300 to 400 square foot project, according to one cost comparison. Water should run away from your house, so this is worth pricing at the start.
Extras. Steps, retaining walls and sealers each add their own line. The local contractor guide above puts coatings and sealers at $2 to $5 per square foot and retaining walls or steps at $20 to $40 per square foot. Retaining walls over 4 feet need a permit in St. George, per the June 2026 Southern Utah guide, so confirm with the city before you design a tall wall into the plan.
Removing an old patio. If you are replacing a slab, demolition and haul-off are separate line items. Our guide to the cost to replace a concrete patio covers that scope.
One budgeting mistake shows up repeatedly in contractor guidance: pricing only the material. The same Southern Utah guide says total patio cost often runs two to three times the material cost once labor, excavation and drainage are counted.
How to price your own patio step by step
A reliable number needs the real footprint of your project, not a rounded guess. This is the routine we recommend.
- Measure the footprint. Walk the area and note length, width and any curves. Measuring by tape is where small errors creep in: a patio that is 2 feet longer than you thought adds 24 square feet on a 12-foot width. On our map you draw the patio directly on aerial imagery of your property, and the tool calculates the area for you.
- Choose the surface. Pick plain concrete, a colored or stamped finish, pavers or stone. Costs differ by two to four times across that list, so decide before you request prices.
- List the extras. Steps, borders, a seat wall, sealer, lighting and a connection to a walkway all belong in the scope. Drawing each element on the map keeps it from being forgotten, and forgotten items are where change orders come from.
- Note the site conditions. Slope, access, an existing slab to remove and where water currently flows all affect price. Photos help a contractor see them without guessing.
- Get a locally adjusted range first. A planning range built from your dimensions and local cost data tells you whether your budget fits the project before anyone visits. Our Utah concrete estimator is built for this step.
- Send the same scope to each contractor. When every bid starts from identical drawings and measurements, differences in price reflect real differences in work.
Step 6 is where most homeowners lose the thread. A low base bid that leaves out gravel, forming or sealer is the most common source of overruns, one 2026 guide notes, and it recommends getting three written bids that spell out square footage, finish, slab thickness and reinforcement type. A shared scope packet makes those line items hard to skip.
Reading and comparing patio bids
Once bids arrive, compare them on scope before price. Check that each one states:
- The exact square footage and the finish
- Slab thickness and reinforcement, such as rebar or wire mesh
- Base material and depth, plus any excavation or grading
- Control joints, sealer and cleanup
- What happens to removed concrete or soil
- Who pulls any required permit
If you have never sat down with a contractor on a project of this size, a home remodeling consultation checklist walks through what to bring, ask and expect, and most of it applies to an outdoor project too. Bring your drawing, photos and a target budget, and ask each contractor to price the same items in the same order.
Our perspective
Most people searching for a patio price want one number, and no honest one exists until the patio has dimensions. A 12-by-12 pad and a 500-square-foot entertaining space share a keyword but nothing else. The published ranges in St. George are useful for budgeting, and then they stop being useful.
What closes the gap is a drawing. When you outline the patio on satellite imagery, add the steps and the border, and see a range adjusted for local costs, you are no longer guessing at square footage or arguing about scope. You also hand the contractor exactly what they need to quote accurately, which tends to produce better-matched bids and fewer surprises.
We built the platform around that idea: design first, then ask for quotes, with no account required to start. If your patio is one piece of a larger backyard plan, the same map can hold a deck, a fence or a pool beside it, so the whole budget lives in one place.
Christian
Draw your patio and get a St. George range
Our Concrete Estimator lets you outline your patio on a satellite view of your property, set the finish and extras, and see a locally adjusted planning range right away. When the scope looks right, you can request quotes and contractors receive drawings, measurements, options and photos together, so every bid starts from the same plan.

If you want a broader write-up first, our concrete patio cost guide by size and finish is a good companion to the local numbers above.
FAQ
What is the average cost of a 12x12 concrete patio in St. George?
Expect roughly $1,500 to $3,000 once a typical contractor minimum is included. Pure per-foot math at St. George plain-concrete rates gives about $864 to $1,296, but small jobs are often priced as a minimum charge. Stamped finishes and difficult access push the total higher.
How much does a 300-square-foot stamped concrete patio cost?
About $3,600 to $5,400 at a national installed range of $12 to $18 per square foot, itemized in a 2026 breakdown. Local St. George stamped rates of $10 to $18 per square foot give a similar span of $3,000 to $5,400. Stamping labor is the largest single line, followed by concrete, base and sealer.
Why are patio quotes so different from one contractor to the next?
Scope differs more than price does. One bid may include a compacted gravel base, thicker slab, reinforcement and sealer, while another leaves them out. Asking every contractor to quote the same drawing and the same list of items makes the totals comparable.
Do I need a permit for a patio in St. George?
A ground-level patio is a different case from walls and structures, so confirm your project with the City of St. George. A Southern Utah contractor guide notes that retaining walls over 4 feet require permits in St. George. If your design includes a tall wall, ask your contractor who handles the permit.
Sources
- Concrete patios in St. George, rate and process page
- Concrete in St. George, UT rate table
- Calculating concrete patio installation costs in St. George
- Concrete vs pavers in St. George: cost and durability
- Hardscape contractor guide for St. George, UT
- Concrete Network patio cost guide
- Concrete patio cost per square foot breakdown
- Flagstone vs pavers cost comparison
- Home remodeling consultation checklist